YARNS INIT doesn't work anymore

Hi everyone,

Pulsar is gone, had to come back to my YARNS with the 4T layout.
I just realized that my INIT procedure as my SAVING procedure don’t work anymore…
My all 8 own presets are full and i just want to cancel it, like just INIT them all , or at least just one…
I updated with the last firmware 1.5 believing it would reset everynthing, but no
I do know there is no reset procedure
But why can’t I init my preset anymore…

Select I(NIT) and click the encoder to reset the current settings to basic settings (120 BPM, mono layout, no arpeggiator or sequencer).

Blockquote
i know and read this, and try and try this
but nothing…
i m a bit stuck here…

I have to mention that recalling a preset by LOADING works…
but neither SAVE or INIT…
why so ?
anay idea ?

STEF

That’s strange. Can you post a video?

Note that:

  • Updating the firmware doesn’t erase any of the presets.
  • The INIT function only resets the current settings of the module. Nothing is permanently saved until you decide to save to one of the 8 presets.

Updating the firmware doesn’t erase any of the presets.
The INIT function only resets the current settings of the module. Nothing is permanently saved until you decide to save to one of the 8 presets.

yes i know that, no worries , i will post a video tomorrow morning
Thank you for your quick answer
Stef