Updated Firmware Issue (SOLVED)

Hello, I have an old Shruthi board that works fine. The firmware was 0.97. I was able to successfully upgrade to version 1.02 via midi. After reboot, there I noticed that I can’t change the new system settings: “Start screen”-Option. The rotary encoder and the 4th potentiometer work well … is there a reason for that?

Best regards,

Is the sna setting set to on? Temporarily set to off, you’ll be able to adjust all settings that have been assigned random values following the firmware update.

Thanks - that’s it.

Hello, i setup sna = on but after upgrade to v1.02 when i plug it, not welcome screen message (“Mutable Instruments v1.02”) is shown.

Any idea?


Maybe the startup screen setting is incorrectly set?