Trying to run shruthi into my TC Fireworx

Hello,

I’m trying to run my 1/4 mono out into my TC fireworx. Im making my own cable since i dont have one of these at hand.The TC unit has only xlr in and out. I’m a bit confused where to solder the 3rd wire.

The TC unit says Pin 2+/Pin 3- on the back.

Do I do
XLR 1 - Sleeve
XLR 2 - Tip
XLR 3 - Tip

Or
XLR 1 - Sleeve
XLR 2 - Tip
XLR 3 - Sleeve

Or
XLR 1 - Sleeve
XLR 2 - Tip
XLR 3 - No Connection

I currently have it the first configuration, but am scared to turn it on. Is that the right way? I might be wrong. In fact I think I’m not correct here.

Thanks

Lots of info about this online :wink:

This page should help? http://www.shure.com/americas/support/find-an-answer/how-do-i-wire-an-xlr-to-1-4-adapter-cable

The first of the 3 possibilities listed there (which matches your second option) looks to be what you need.

And theres no need to be scared. You won’t blow anything up if you get it wrong.

OK thanks a lot, I knew I was wrong, just saw so many different pinouts online and started to question myself. I appreciate it!