Trim pots

Looks like there are trimmers with the screws on the sides instead of the top. Would make it easier to tune without having to “unsandwich” your shruthi…

M64X502KB40

Yes, I am using those on the next batch of kits and on the mkII board.

On the following filter boards they won’t be of much help since the trimmers are not laid out near the edge of the board:

  • SSM2044
  • CEM3379
  • IR3109

On the dual SVF board these can be used.

As seen here on a SMR 4 MK 2 board.

Its a little awkward, but you can just about access it through the hex side panels of a fully assembled Shruthi too.

nice!