Tides v1 no longer responding to v/oct or FM

It was working absolutely fine for the last 2 days, and now no response from either input into v/oct or by turning frequency knob. I’m not in PLL mode either.

Any ideas?


Is it possible for it to go out of calibration so suddenly? I’ll give it a shot today and let you know if that work.

If you entered the calibration mode by mistake, yes!

The issue you describe is consistent with sending the same voltage to the CV input during the two steps of the calibration procedure, which might have been caused by accidentally entering the calibration mode and pressing twice the button to skip to the next step.

Otherwise, the module does not go out of calibration.

Thanks Emilie! Yes, I’ve corrected it as described above. I need to be less enthusiastic about my button pushing.