Solder Pad Question

So, I’m finished soldering my SMR-4 mkII.
Except from one small mistake - one solder pad for the 10k resistor next to C15 came off from the backside during desoldering.

What to do?

You could try to solder it from the ‘up’ (parts) side. You could have the resistor a little higher standing on its legs to leave some room for soldering. Other option is to use a little piece of wire to connect it to where it should go.

Thanks!

if you manage to make contact to the top side you may want to check the other side (or even better the schematics) if there needs to be another connection on the bottom side, just to be sure.