Shruthi Midnight Edition problem(SOLVED)

Hi everyone, I’m new here,
So I’m building the filter board and it’s going pretty well, I got to step 5( http://mutable-instruments.net/shruthi1/build/svf2 )and plugged in a wall wart but the Voltage measured -5v at the +5 test spot, and +5v at the -5 test spot. the wall wart seems to have the correct specs and polarity. I did try a couple others i had lying around but I later realized one was the wrong polarity and the other was actually putting out 14v instead of 9, I hope that didn’t destroy anything? thanks for any help!

Here’s a few pictures if it helps, thanks

> and plugged in a wall wart but the Voltage measured -5v at the +5 test spot, and +5v at the -5 test spot. the wall wart seems to have the correct specs and polarity

Maybe you were not making the measurement correctly then?

Try this wallwart again and be careful when you take the measurement, it should work!

Ok thanks for your response, I’ll try again and see

Ah got it, the problem was with the multimeter cables, now to carry on…thanks

solved