Possible to disable sending parameter changes in Polychain mode?

When you have a couple of Shruthis set up in polychain mode, parameter changes made on the first Shruthi are forwarded down the line to the others. Is it possible to disable this so that you can set parameters on each shruthi individually?

Not without a firmware change…

That’s unfortunate. Could I hook three Shruthis up to different outputs on a midi splitter and set them up as 1-|, 2-1, and 3-2? Do they select the notes to play on their own, or do they have to be hooked up in line so the first can dispatch the notes to the others?

Consider getting a MIDIpal. You can use the Dispatch mode and parameter changes are not sent down the line.

> Could I hook three Shruthis up to different outputs on a midi splitter and set them up as 1-|, 2-1, and 3-2? Do they select the notes to play on their own, or do they have to be hooked up in line so the first can dispatch the notes to the others?

No, they have to be on the same line. That’s why they all have to be set to a different polychaining setting - to know exactly how many units are down the chain.

Ok, thanks… Might think about a second MIDIpal or some programming then.