Mounting leds/pots/buttons off board

is there anything that would stop someone from doing this? apart from the potential for the wiring to turn into a rats nest fairly quickly…and making everything a bit more difficult in general…

would there be a problem with any extra noise introduced by such a build?

Buttons and LEDs are not sensitive to noise of course. Regarding the pots, it’s a different story, because if you get more than 1/127 of Vcc of noise, the parameters affected to the pot will deviate a bit around its central value - which will be a problem when you switch a different page because this can result in a drastic change.

hmm. thanks. i guess I’ll wait and see. more than likely i won’t bother. sounds like it could be too much hassle…

thanks.