Frames trimming

Hi all,
I’d like to know if it’s possible to trim adjust the knobs on Frames. I’m asking because it seems as the 4 circuits are all offset with each other. The knobs should all have the same range/behaviour, correct? Or am I missing something such as calibration procedure and/or options about the single pot range? I know there is a way to decide the morphing behaviour but perhaps I overlooked something…
Thanks :slight_smile:
M

You can configure the response of each channel from linear to exponential. I bet that’s what’s causing the discrepancy you observe.

Good one thanks, I’ll try!

yep that was it, thanks!