Frames Calibration

Hello !

I don’t find some clear answer…

So, does anybody know how we proceed for the Frames calibration ?

And do I need some tuner ?

Thanks for your answers

Why do you want to do this? Why do you think you need a tuner?

I want to test the parasite firmware and in the instructions it’s write I must calibrate the module after the installation.
What is the calibration procedure ?

(On some module I have see, we need some tuner for calibrate)

I would like to test the parasite firmware and in the instructions, there is write, we must to calibrate the module after the installation.
So, what is the calibration procedure on the Frames ?
How can I make it ?

(I think maybe we need a tuner because it seem on other module (like vco), for set the 1 volt/oct we need a tuner for the note)

You don’t need a tuner.

The calibration procedure is probably described in the Frames parasites manual.

Yes I have read that:

“It is crucial to calibrate your module after updating. To calibrate, unplug all cables from Frames and hold the Del button while the module is powering up”.

But is that the only thing I must do ?
Not turning buttons or other ?

Thanks for your answers :smiley:

Yes.

Ok nice, thanks.:sunglasses: