DIY Grids is all or nothing on one channel

I have a Mutable Grids with two channels that work fine, but the third channel is either all or nothing. With the knob at 0 to 50%, I get nothing out of it. From 50% to 100%, I get the firehose. I had this problem once before, but it was long ago and I don’t remember how I fixed it, if I ever actually knew to begin with.

I’ve used every combination of settings and configurations with no results. I’m clocking it with Pamela’s New Workout.

Any thoughts?

If it’s DIY, it’s not Mutable Instruments’ responsibility to provide support for it!

1 Like