Custom Tunings on Yarns Er message

I’m trying to put some custom tuning onto yarns and seem to be getting the ER message every time. I created the .syx files using the online tool provided, and am transferring them using c6 tools. I had no problems updating Yarns so I know my set up was working at least last week. Am I correct in powering up holding down the encoder, like I did when updating? I’ve tried changing around the delay I’m not sure what I’m doing wrong.

> Am I correct in powering up holding down the encoder, like I did when updating?

No. You’re not doing a firmware update, so you don’t have to do all this.

Just send the data when the module is powered on normally. It would be silly if you had to power off and on your system just for a little scale change :slight_smile:

Whoops!