BOM Module Tester

Does somebody have a Mouser (or other) BOM for the module tester please??

Hello @lcf

You can find it MI Website under Other Projects/Module Tester

Here is a direct link

Thanks.
Is there any replacement part for MC74HC165ANG please?

Yes, any DIP 74hc165 will do :slight_smile:

Nice, thanks!

What about DIP 8/14/16 sockets please? I have troubles to find them on Mouser…
And I see no socket for the Atmega, is it normal?

> What about DIP 8/14/16 sockets please? I have troubles to find them on Mouser…

Use their search function?

> And I see no socket for the Atmega, is it normal?

No.

I finally found them on reichelt.

Thanks Olivier to provide all the references for Reichelt etc… And this module tester

A last question, is this power supply ok please?

http://www.mouser.fr/ProductDetail/Mean-Well/GE24I12-P1J/?qs=sGAEpiMZZMt5w6YCUaBPUQC4BcBYYiSGNym6%2FzwA2TE%3D

Looking the datasheet it seem to be ok but about the amperes, is 2a. too much??

Thanks again

No, you need an AC supply.

Does anyone has a cheap suggestion for the power supply please?
I really have troubles to find one with AC output.

Where do you live?

I live in France.

This

Thanks a lot I did not think that 9V would be good

Oops… This

Thanks again!!

I built my tester and everything is working fine except the leds…
I bought the pcb from Thonk and there was no polarity indicated. So i mounted them with the longest pin down…
Do i have to inverse them please?

LEDs have to be mounted with the shorter leg (cathode) down. It’s normally indicated with a flat edge on the LED and corresponding image on the PCB

Thanks mate!!

Cv out cycles between 1V and 2,93V.
Could I get it more accurate?

Adjust the trimmers :slight_smile: