Assigning all voices to part 1 by default - possible?

Forgive me if this has been asked before, or whatever - I just finished an ambika, and don’t know much about it yet.

By default, on bootup, voices 1, 3 and 5 are assigned to part 1, and voices 2, 4 and 6 are assigned to part 2. While this makes a kind of sense, I was wondering if there’s a way to have it boot up with all 6 voices assigned to part 1?

Yes.

Configure the synth with whatever settings you want it to boot with, then press S8 (load/save), S7 (“more”), S2 (">ini") and S7 (“yes”). The current settings will be saved and reused whenever the synth boots.

1 Like

Thank you!

I found this thread helpful, thank you! I knew this had been answered before.

Before I change it to what the OP suggested I would like to understand the choice of actually having 1, 3 and 5 to part one and voice 2, 4 and 6 assigned to part two.

2 parts of 3 voices. Why 1 3 5 and 2 4 6 instead of 1 2 3 and 4 5 6? 1 3 5 corresponded to the first “layer” of voicecards, those directly connected to the motherboard.