This is weird. What could have happened? I was using the sequencer, drums on. Whenever I turn some pot in lowest row, osc changes pitch. I cannot adjust for ex. drums sounds. Any suggestions?
Have you tried turning it off, and on again?
Yes. I opened it, reheated evety solder joint - no help
You must have shorted or bridged something, somewhere. Id first investigate the stacking connectors for conducting debris….
Usually I am quite careful with those. And now it works, when it is all alone. Go figure. I must test it now with modular again - even if it didn’t connect anywhere else than clock out to sequencer…?