Anushri boot failure?

Hey guys

My Anushri is built and all the voltages check out perfectly. I also get a small reassuring audio ‘thump’ on power up.

The unit always powers up with three LEDs lit: Left-lower, Left-upper, Top-middle.

Holding any of the keys on power-on has no effect whatsoever. Also the keys do nothing generally, of course.

What’s the next recommended check please?!


So it looks like your Anushri locks itself in firmware update mode because it thinks one of the switches is pressed during boot. Are you sure the 10k resistor network is correctly soldered?

oops haha silly me, I’d only tacked it in at one end! not sure how I didn’t spot it?

thanks mate!