This discussion was created from comments split from: Census of successfully assembled kits.
Looking sharp! The Albs (Waldorf) knobs are nice.
yep, but it’s not too difficult to tweak without indicator ?
I would love to use my transparent waldorf one, and put some led on the back, but don’t know where to take some current…
It’s way less than 20mA per LED. You can tap the 9V DC directly with a resistor (plus trimmer maybe) and use it for the LEDs backlighting any transparent knobs.
“yep, but it’s not too difficult to tweak without indicator ?”
not really because I use the Snap Mode for the encoders
maybe later I will use a black pen for mark the position